BL 981411 pH controller has been designed for easy, affordable installation in tight spaces, ideal for simple and effective process control. The unit is provided with differential pH input and can be used with any pH electrode with standard BNC connector. Measurements are clearly displayed on the large LCD, while the status LED indicates operating mode.

BL 981411 is also provided with a dosing relay. Selecting acid dosing, will cause the relay to activate when the measurement is higher than the set point. If the basic dosing is selected, the relay is activated when the reading falls below the set point.

Set point adjustment (from 0 to 14 pH) and calibration procedures are easily performed with trimmers on the front panel. You can also choose from automatic or manual dosing modes with a switch on the front panel. Manual control is particularly useful during maintenance operations, because it permits you to enable or disable the dosing relay according to your need. An overtime control system advises you when the relay is active too long, to help prevent overdosing.

Two models are available, with power supply input at 115/230 Vac or 12 Vdc.

The BL 981411 is supplied with mounting brackets, transparent cover and instructions. Order pH electrode separately.

Range pH 0.0 to 14.0 pH
Resolution 0.1 pH
Accuracy 0.1 pH
Calibration manual, with offset trimmer
Dosing Relay 1, max 2A (fuse protected), 250 Vac, 30 Vdc
Dosing Selection acid or alkaline
contact open = acid dosage, activated when reading exceeds setpoint value
contact closed = alkaline dosage; activated when reading falls below setpoint value
Setpoint adjustable from 0.0 to 14.0 pH
Overtime adjustable, typically from 5 to approx. 30 minutes
Input Impedance 102 Ohm
Power Supply 12 VDC
Dimensions 83 x 53 x 99 mm (3.3 x 2.1 x 3.9")
Weight 7.1 ounces

Item Specifications
Part Number: 134107
Dimensional Weight: 1 lbs

Additional Documents:   

	Instruction Manual	241 KB	Modified: 4/14/2010
	Literature	931 KB	Modified: 4/14/2010